Products

Mold Release Concentrate

Newcomer Supply Beaker

(use: Help blocks release from embedding molds.)

      • Shelf Life is 2 years from date of manufacture.

Product Options:

1 - 5 (each):
Part # 1246A 120 ml $15.90 H
6 or more (each):
Part # 1246A 120 ml $13.30 H

SOLUTION:

120 ml 120 ml X 6
Mold Release Concentrate Part 1246A Part 1246A

 

Additionally Needed:

Alcohol, Ethyl Denatured, 100%
                  OR
Alcohol, Isopropyl ACS, 100%		 Part 10841
    OR
Part 12094
Base Molds, Stainless Steel, Heavy Duty Part 5103
Base Molds, Stainless Steel Part 5104
Base Molds, Disposable Part 5105

 

For storage requirements and expiration date refer to individual bottle labels.

 

APPLICATION:

Newcomer Supply Mold Release Concentrate, when diluted to a working mold release solution, facilitates the clean release of cooled, solidified paraffin embedded tissue blocks from tissue embedding base molds.

 

METHOD:

Solutions:  All solutions are manufactured by Newcomer Supply, Inc.

 

PROCEDURE:

    1. Dilute Mold Release Concentrate to a working solution. Combine solutions in a plastic spray bottle and mix well;
        1. Mold Release Concentrate         5 ml
        2. Ethyl Alcohol or Isopropyl Alcohol       95 ml
        3. Store unused Mold Release Working Solution at room temperature for up to 6 months.
        4. Keep working solution tightly capped when not in use.
    2. Arrange clean and dry stainless steel base molds (Parts 5103, 5104) or disposable base molds (Part 5105) on paper towels or bench paper in a ventilated area.
    3. Spray all embedding base molds thoroughly with Mold Release Working Solution, allowing small beads of solution to form on base mold surfaces that will come in contact with paraffin.
        1. See Procedure Note #1.
    4. Allow embedding base molds to thoroughly air dry prior to use.
        1. Thorough drying of base molds is necessary to avoid residual Mold Release Solution mixing with paraffin during embedding process.
    5. Embed paraffin processed tissue in embedding base molds that have been treated with Mold Release and dried.
    6. Cool paraffin blocks on embedding center cold plate.
    7. After paraffin is solidified, cooled tissue blocks will easily separate from embedding base molds.
        1. See Procedure Note #2.
    8. Repeat treatment of clean and dry base molds with Mold Release Working Solution on a routine basis.

 

PROCEDURE NOTES:

    1. Spraying embedding base molds provides a better adherence of Mold Release and preferred over soaking base molds in solution.
    2. If tissue blocks are difficult to remove from embedding base molds, a sharp tap of the base mold on the bench top will facilitate removal.

 

REFERENCES:

    1. Sheehan, Dezna C. and Barbara B. Hrapchak. Theory and Practice of Histotechnology. 2nd ed. St. Louis: Mosby, 1980. 66.
    2. Modifications developed by Newcomer Supply Laboratory.